Audi Q7 ACC Setting Device VAS6190 , Converting for Adjustment Procedure

ACC Setting Device VAS6190 , Converting for Adjustment Procedure


Audi Q7
Special tools and workshop equipment required ACC Setting Device VAS6190

Before performing adjustment, check in which mount the vertical slits on the ACC Setting Device VAS6190 are located. ACC Setting Device VAS6190 may have to be adapted before performing adjustment.

The ACC Setting Device VAS6190 must be adapted before adjustment procedure. If this is done during the adjustment procedure, the pre-calibration on the ACC Setting Device VAS6190 must be repeated.

For the adjustment procedure, the vertical slits in mounts 1 through 4 must be inserted so that laser beam is approximately centered vertically when it contacts the sensor lens.
Chassis|Suspension, Wheels, Steering|Wheels, Tires, Wheel Alignment|Adaptive Cruise Control (ACC)|Setting Device Basic Set  VAS6430/1 Converting, for the Calibration Procedure
The original nut at the top of the horizontal slits must be replaced with a standard nut 3 .
Chassis|Suspension, Wheels, Steering|Wheels, Tires, Wheel Alignment|Adaptive Cruise Control (ACC)|Setting Device Basic Set  VAS6430/1 Converting, for the Calibration Procedure
Note The original nut at the top of the horizontal slits must be replaced with a standard nut so that the mirror can be slide far enough to the center. The mirror at the center 1 must be removed and installed again all the way to the left arrow near the vertical slits 2 .
Chassis|Suspension, Wheels, Steering|Wheels, Tires, Wheel Alignment|Adaptive Cruise Control (ACC)|Setting Device Basic Set  VAS6430/1 Converting, for the Calibration Procedure
Then the mirror 1 must be slide on horizontal slits as far as stop on vertical slits 2 .
Chassis|Suspension, Wheels, Steering|Wheels, Tires, Wheel Alignment|Adaptive Cruise Control (ACC)|Setting Device Basic Set  VAS6430/1 Converting, for the Calibration Procedure