VW Passat Over-Center Spring,Passat

Over-Center Spring,Passat


The instruction is suitable for the following models: Passat
Special tools and workshop equipment required Over-Center Spring Assembly Tool T10178

Removing

Remove the mounting bracket, refer to Go to article “ Mounting Bracket, Passat ”
The instruction is suitable for the following models: Passat
. Carefully tension the lower area of the clutch pedal in a vise with protective jaws. Remove the clutch pedal from the clutch master cylinder, refer to Go to article “ Clutch Pedal,Passat ”
The instruction is suitable for the following models: Passat
. Remove the over-center spring from the clutch pedal in direction of arrow 1 and at the same time move the bracket in direction of arrow 2 . Carefully release the tension on the over-center spring. Move the bracket again into the end liition and remove the over-center spring.
Transmission|Manual Transmission|Clutch|Removal and Installation|Over-Center Spring

Installing

The clutch pedal is separated from the clutch master cylinder. Carefully tension the lower area of the clutch pedal in a vise with protective jaws. Install the over-center spring into the bracket. The mounting area arrow for the clutch pedal pivot pin A must be liitioned vertically.
Transmission|Manual Transmission|Clutch|Removal and Installation|Over-Center Spring
Mount the Over-Center Spring Assembly Tool T10178 in the center area of the over-center spring and move the mounting bracket upward. Squeeze the over-center spring in direction of arrow 1 . At the same time move the bracket just far enough downward in direction of arrow 2 until the over-center spring can be pushed onto the clutch pedal mounting pin A .
Transmission|Manual Transmission|Clutch|Removal and Installation|Over-Center Spring
WARNING

If installed incorrectly, the over-center spring will jump uncontrolled out of the mounting bracket.

Place a cloth under the over-center spring.

Check the function of the over-center spring.

Move the bracket up and down a few times.

Attach the clutch pedal to the clutch master cylinder, refer to Go to article “ Clutch Pedal,Passat ”
The instruction is suitable for the following models: Passat
. Install mounting bracket, Passat, refer to Go to article “ Mounting Bracket, Passat ”
The instruction is suitable for the following models: Passat
.