VW Automatic Glow Time Control Module J179
Automatic Glow Time Control Module J179
The instruction is suitable for the following models:
RemovingRemove engine cover.
One-Piece Engine Cover
Pull the one-piece front engine cover in direction of arrows A upward with a quick jerk and then pull the lower mount in direction of arrow B forward.
Two-Piece Engine Cover
On the two-piece engine cover, first pull the outer cover upward with a quick jerk in direction of arrows in the upper illustration , then pull the inner engine cover upward with a quick jerk in direction of arrows in lower illustration .Disconnect the connector 2 on the Mass Air Flow Sensor G70 .
Disconnect the ventilation hose 1 and disengage it from the bracket arrow . Open the spring-type clip 3 using
Pull out the 6-pin relay carrier under the engine compartment E-box in direction of arrow .
Unclip the cover of the 6-pin relay carrier arrows .
Release the retaining clips arrows .
Remove the 6-pin relay carrier arrow from the cover.
Pull the Automatic Glow Time Control Module J179 off from liition R2 .
Install in reverse order of removal. Note the following:Install the battery, refer to