VW Passat Clutch Pedal,Passat

Clutch Pedal,Passat


The instruction is suitable for the following models: Passat
Special tools and workshop equipment required Clutch Pedal Pliers T10005 Torque Wrench 1331 5-50Nm VAG1331 Over-Center Spring Assembly Tool T10178

Removing

Remove the mounting bracket, refer to Go to article “ Mounting Bracket, Passat ”
The instruction is suitable for the following models: Passat
. Carefully tension the bracket in a vice. Use jaw protectors. Remove the nut 2 and the bolt 5 and then remove the clutch pedal 1 from the bracket 3 .
Transmission|Manual Transmission|Clutch|Removal and Installation|Clutch Pedal
Move the clutch pedal foreword and remove the over-center spring 4 . Release clutch pedal from master cylinder with Clutch Pedal Pliers T10005 . Remove the clutch pedal.
Transmission|Manual Transmission|Clutch|Removal and Installation|Clutch Pedal

Installing

Install in reverse order of removal. Note the following:

Note Replace the self-locking nuts. Install the mount 2 on the clutch master cylinder actuator rod 1 .
Transmission|Manual Transmission|Clutch|Removal and Installation|Clutch Pedal
Press mount until it engages audibly in notch on clutch pedal 3 . Install the over-center spring 2 into the bracket from the top and hold the end of the spring in its installed liition using the Over-Center Spring Assembly Tool T10178 .
Transmission|Manual Transmission|Clutch|Removal and Installation|Clutch Pedal
Insert the clutch pedal pivot pin 1 into the mounting cup of the over-center spring. Press the clutch pedal slightly, push the bolt through and tighten the self-locking nut. Install the bracket, refer to Go to article “ Mounting Bracket, Passat ”
The instruction is suitable for the following models: Passat
.

Tightening Specification

Component Nm

Clutch pedal to bracket Replace the self-locking nuts. 25