VW 3C Shift Knob, Boot and Noise Insulation

Shift Knob, Boot and Noise Insulation


The instruction is suitable for the following models: 3C,Passat CC
Special tools and workshop equipment required Hose Clamp Pliers VAG 1275 Special Hook 3370

Removing

Open the ashtray.
Transmission|Manual Transmission|Controls, Housing|Removal and Installation|Shift Knob, Boot and Noise Insulation
Push the Special Hook 3370 all the way under the plastic frame for the boot arrow 1 . Remove the boot with plastic frame from the center console frame A in the direction of arrow 2 Hold the frame for the center console A tight.

It must not be removed.

Connectors for various switches could be loosened unintentionally.

Roll the boot up over the shift knob. Open the clamp arrow and remove the shift knob and boot.
Transmission|Manual Transmission|Controls, Housing|Removal and Installation|Shift Knob, Boot and Noise Insulation
Remove the noise insulation, if equipped.

Installing

If equipped, insert the noise insulation first. Noise Insulation, Installed liition
Transmission|Manual Transmission|Controls, Housing|Removal and Installation|Shift Knob, Boot and Noise Insulation

The A arrow points in the direction of travel.

The tabs B arrows must latch into the center console.

Turn the inside of the boot toward the outside.

Install the shift knob all the way on.

Install the shift knob and boot and squeeze the new clamp arrow together.
Transmission|Manual Transmission|Controls, Housing|Removal and Installation|Shift Knob, Boot and Noise Insulation
First, insert the boot plastic frame at the rear.